Project by Stephanie Marsh
You will need (for 6 crowns):
½ m red fabric
½ M green fabric
3m red ½ inch satin ribbon
3m green ½ inch satin ribbon
½ m stiff iron on interfacing
Coordinating thread
CROWN TEMPLATE – either use the one attached, download one or free draw one
Instructions:
1. Cut 6 crowns from red fabric, 6 from the green and 6 from the interfacing.
2. Iron the interfacing onto the back of all the green crowns.
3. Cut the ribbon into 50cm lengths and please in the middle of the right side on the short edge / side of the crown with the long lengths coming to the centre.
4. Take the red crowns and place on top of green crowns, right sides together.
5. Stitch up the side, around the points and down the other side using a ¼ inch seam allowance. Clip the corners and into the points.
6. You can also trim the seam allowances with pinking shears and trim away excess around the points.
7. Turn right sides out, be careful not to poke the points out too much as you may get the raw edges poking through.
8. Press.
9. Turn ¼ inch under to wrong side on straight edge on both the e green and red fabric. Press.
10. Topstitch the long edge closed, then continue all around until you get back to the start again. Press.
To see more from Stephanie, follow her on Instagram @stephanie_j_marsh, and make sure to check out her other Christmas table fun projects!
Made by Stephanie Marsh for The Craft Cotton Co 2022.
Comments